29.3mm Sliding Door Roller – Suits Hanging Doors

A direct replacement sliding door roller for hanging doors. Threaded axle. Acetal convex roller with bearing. Suits Trak™, Sylon Junior, Smart Home Products, Centor™ and Henderson. Roller only — carriage not included. Pairs with our 29mm Sliding Door Trolley & Acetal Roller (CAR29STL58).

Key Features

• Acetal construction
• Acetal convex roller with bearing
• Threaded axle
• Overall 28.7 x 29.3mm
• Roller only — carriage not included
• Australian stock, dispatched within 5 business days

Fits & Replaces

• Direct replacement for Trak™, Sylon Junior, Smart Home Products, Centor™ and Henderson hanging door rollers.
• Match the 29.3mm roller diameter, the convex profile and the threaded axle against your existing roller — if those match, it fits
• Print the Actual Size Identifier below and lay your old part straight onto it — that confirms the fit in seconds

Specifications

• TradeBase SKU: ROL29CVX
• Material: Acetal
• Roller profile: convex, on bearing
• Axle: threaded
• Overall size: 28.7 x 29.3mm

Installation Tips

• Match the new roller to the old one on diameter, profile (concave, convex, flat or V-groove) and axle — this one uses a threaded axle, so check the thread on your old roller before ordering.
• Check the track for burrs and flat spots and file them smooth — a damaged track will chew out a new roller within weeks.
• Clean all grit and old grease out of the track. Grit is what kills a roller, not load.
• Replace rollers in pairs. A new roller running against a worn one carries uneven load and both wear out early.

Care & Maintenance

• Use a dry lubricant only — silicone or dry PTFE. Oil and grease hold dust and grind the roller.
• Sweep the track out every few months, more often in coastal or dusty areas.

Warranty

Covered by our 12-month warranty and your rights under the Australian Consumer Law.

Check the fit before you buy

Download the TradeBase Actual Size Identifier (PDF) and print it on A4 at 100% / Actual size — not Fit to page. The part is reproduced at true 1:1 scale on a 10 mm grid and measures 28.7 mm overall. Lay your existing part straight onto the page to confirm it matches. A calibration bar on the sheet lets you check the printer has not scaled the page.